Materials used

MODELS IN WOOD: Structure melamine or lacquered standard colors.
"Upholstered" MODELS: Structure in wood particles covered with foam rubber combined with fabrics, eco-leather or leather

Assisted net lifting devices with hydraulic/pneumatic piston with thrust speed from 100 to 300 mm/sec and a maximum force of 1000 N (approximately 98 kg). EXCESSIVE STRESSES AND STRESSES OF THE LIFTING SYSTEM MUST BE ABSOLUTELY AVOIDED (OVERLOAD OR FALLING OBJECTS OR LATERAL THRUSTS DURING OPENING). AVOID ACCESS OF CHILDREN BELOW THE NET WHEN LIFTING

Metal alloy or plastic hardware. For upholstered beds the feet are in melamine or wood.

Use and Maintenance

Assembly and installation

Preliminary information for use:
The product is supplied packaged to prevent damage, however it must be handled with care and avoid knocks and falls that could damage the product. For handling it is recommended to use mechanical or manual equipment in order to limit the effort.
Do not expose it to bad weather or extreme environmental situations (temperatures <0 ° C or> 35 ° C; relative humidity> / = 70%).
When opening the packaging, do not use sharp objects (cutters) and pay the utmost attention not to damage the product
For the products to be assembled, contact specialized personnel
After the first year of use and every three years it is advisable to adjust the screws, check that there is no damage to the product

Use of product

The use of the product must comply with the type of indoors product and with temperatures between 0 ° C and 35 ° C; relative humidity less than or equal to 70%. Do not expose it to direct sunlight or sources of heat, which could accelerate its obsolescence as well as modify its brightness and uniformity of color and external finishes. Avoid collisions with hard or sharp objects on the surfaces

The capacity of the bed with combined slatted base and mattress provided by Giessegi is 100 kg for the single and 160 for the double
EXCESSIVE STRUCTURE STRESSES AND STRESSES MUST BE ABSOLUTELY AVOIDED (OVERLOAD OR FALLING OBJECTS)
In case of access to the storage compartment make sure that there are no loads superimposed on the bed base over the mattress, linen and blankets. The lifting mechanism tends to close with a thrust of 10 kg.
THE PRESENCE OF CHILDREN IN THE CONTAINER COMPARTMENT OR EXPOSED TO THE RISK OF FALLING OF THE LIFTING NET MUST BE ABSOLUTELY AVOIDED.

Maintenance

To clean the “wooden” surfaces of the article, use a cotton or wool cloth or a non-abrasive cloth, soaked in water and then wrung out (not dripping); then wipe with a dry (non-abrasive) cloth to dry the surface. Do not scrub quickly and repeatedly. Where the dirt is stubborn it is possible to use household detergents. DO NOT USE ACIDS OR INDUSTRIAL DETERGENTS WHICH COULD DAMAGE THE PRODUCT. For metal components only, it is possible to use industrial solvents as long as they are compatible with the finishes and using non-abrasive supports. IT IS FORBIDDEN TO USE ELECTROMECHANICAL SYSTEMS FOR CLEANING

Any additional information

In the case of lifting devices for the article, make sure that it works correctly before going under the opening. Do not allow access of children under "raised" items. Memory mattress is covered in hypoallergenic fabric, completely removable

Dangerous substances

The panels used for the structure have formaldehyde emission class E1. There are no dangerous substances to report pursuant to Reg (EU) 1907/2006 (REACH)

Life cycle

Although the product can keep its functions for a long period, if used in compliance with this sheet, it is nevertheless designed by the manufacturer to guarantee its technical and aesthetic performance for a maximum period of 2 years.

Information on end-of-use disposal

At the end of use, the product must be delivered to authorized waste treatment / disposal facilities, in accordance with current legislation